LevelOne GSW-2692 - Manual (Page 247)

Flash/File Commands
4-69
4
Command Usage
• If you enter the command dir without any parameters, the system displays all
files.
• A colon (:) is required after the specified unit number.
• File information is shown below:
Example
The following example shows how to display all file information:
whichboot
This command displays which files were booted when the system powered up.
Syntax
whichboot [unit]
unit - Stack unit. (Range: 1-8)
Default Setting
None
Command Mode
Privileged Exec
Table 4-26 File Directory Information
Column Heading Description
file name The name of the file.
file type File types: Boot-Rom, Operation Code, and Config file.
startup Shows if this file is used when the system is started.
size The length of the file in bytes.
Console#dir 1:
file name file type startup size (byte)
----------------------------------- -------------- ------- -------------
Unit1:
D2218 Boot-Rom image Y 214000
V2260 Operation Code N 1751624
V2264-J Operation Code Y 1754316
Factory_Default_Config.cfg Config File N 5013
startup Config File Y 3251
-----------------------------------------------------------------------------
Total free space: 5111808
Console#