LevelOne GSW-2692 - Manual (Page 283)

SNMP Commands
4-105
4
Related Commands
snmp-server contact (4-104)
snmp-server host
This command specifies the recipient of a Simple Network Management Protocol
notification operation. Use the no form to remove the specified host.
Syntax
snmp-server host host-addr community-string [version {1 | 2c}]
no snmp-server host host-addr
• host-addr - Internet address of the host (the targeted recipient).
(Maximum host addresses: 5 trap destination IP address entries)
• community-string - Password-like community string sent with the
notification operation. Although you can set this string using the
snmp-server host command by itself, we recommend that you define this
string using the snmp-server community command prior to using the
snmp-server host command. (Maximum length: 32 characters)
• version - Specifies whether to send notifications as SNMP v1 or v2c traps.
(Range: 1, 2c; Default: 1)
Default Setting
Host Address: None
SNMP Version: 1
Command Mode
Global Configuration
Command Usage
• If you do not enter an snmp-server host command, no notifications are sent.
In order to configure the switch to send SNMP notifications, you must enter at
least one snmp-server host command. In order to enable multiple hosts, you
must issue a separate snmp-server host command for each host.
• The snmp-server host command is used in conjunction with the
snmp-server enable traps command. Use the snmp-server enable traps
command to specify which SNMP notifications are sent globally. For a host to
receive notifications, at least one snmp-server enable traps command and
the snmp-server host command for that host must be enabled.
• Some notification types cannot be controlled with the snmp-server enable
traps command. For example, some notification types are always enabled.
• The switch can send SNMP version 1 or version 2c notifications to a host IP
address, depending on the SNMP version that the management station
supports. If the snmp-server host command does not specify the SNMP
version, the default is to send SNMP version 1 notifications.