Lexmark 5021-0XX - Manual (Page 147)

Diagnostic information 2-69
5021-0XX
993—Fuser clutch service check
Step Questions / actions Yes No
1 Turn printer off and remove
printer right cover. See
“Right cover removal” on
page 4-22
. Disconnect
fuser clutch from cable.
Measure resistance
between two outer pins on
fuser clutch. Does
resistance measure
between 133 and 163
ohms?
Go to step 2. Replace faulty
fuser clutch. See
“Clutch
removal” on
page 4-40
.
2 Remove I/O board shield.
See
“I/O board removal”
on page 4-70 for steps to
remove I/O board shield.
Disconnect cable from
DCN10 on I/O board.
Check cable continuity from
DCN10 pins 5 and 6
(cable) to connector that
attaches to cleaning roller
clutch. Ensure that pins are
not shorted. Is cable okay?
Replace I/O
board. See
“I/O
board removal”
on page 4-70
. If
problem
persists, go to
step 3.
Replace cable.
3 Remove engine controller
board shield. See
“Engine
controller board removal”
on page 4-55
for steps to
remove shield. Check cable
that connects I2CN on
engine controller board to
DCN3 on I/O board for
proper connection,
damage, pin shorting, and
continuity. Is cable okay?
Replace engine
controller board.
See
“Engine
controller
board removal”
on page 4-55
.
Replace cable.