Lexmark 5021-0XX - Manual (Page 87)

Diagnostic information 2-9
5021-0XX
Operator messages
Message Description Action
Change Tray <x>
<type> <size> Printer is requesting
different media than
what is loaded in
specified tray or
defined by paper
size or paper type
settings for tray. Ensure tray contains proper
type and size of media for job.
Remove tray from machine.
Remove paper from tray.
Change paper size length.
Observe paper size sensor
actuator, located on the side of
the tray, movement as you
change to various paper sizes.
Actuator should move back
and forth. If actuator does not
move back and forth, replace
paper tray.
If problem persists, go to
“Paper size sensing service
check” on page 2-87
.
Close Duplex Door Duplex door is
open.
Close Front Cover Front cover is open. Open and reclose front cover.
Ensure that strap connecting
front cover to printer is
attached to printer.
If problem persists, go to
“Cover open service check”
on page 2-75
.
Close Rear Cover Rear cover
assembly is open. Open and close rear cover
assembly.
If problem persists, go to
“Cover open service check”
on page 2-75
.
Close Top Cover Top cover is open. Open and reclose top cover.
If problem persists, go to
“Cover open service check”
on page 2-75
.