Lexmark 5021-0XX - Manual (Page 224)

3-16 Service Manual
5021-0XX
Printer setup
Note: Defaults within this printer can be set to either U.S. or Non-
U.S.
Setting the page count
This lets the servicer change the page count from the diagnostic
menu. This is used whenever the operator panel cable is replaced
because this contains the printer NVRAM memory where the page
count is stored.
To set the page count:
1. Select Page Counts from the diagnostic menu. To enter
diagnostic mode, see “Diagnostic mode” on page 3-4 .
2. Select either Color Page Counts or Mono Page Counts.
The current page count displays and the leftmost digit blinks,
indicating it is the first digit to be changed.
3. Press Menu until the value you want appears.
4. Press Select to move to the next digit.
5. Press Menu until the value you want appears.
Continue with each digit until you set the page count. You can
skip any digit by pressing Select.
6. Press Select to save the new page count in NVRAM.
7. Press Return or Stop to exit the diagnostic menu.
Viewing the permanent page count
Note: The permanent page count can only be viewed; it cannot be
changed.
To view the permanent page count:
1. Select Perm Page Count from the page counts menu.
2. Press Return/Stop to exit the diagnostic menu.