Lucent Technologies CELLPIPE 7820-0766-004 - Manual (Page 20)

Command-Line Interface
Bridging commands
3-4 CellPipe™ 20 Series User’s Guide
save - save and restart modem
show - display configuration of PVC and Ethernet
ver - display software version
Note: *The WAN interface displayed in the menu is dependent on the interface
supported by your unit. This generic form of presentation has been arrived at to
eliminate the need of representing every interface.
Table 3-1 lists the main menu commands and their corresponding second-level
menus. The different WAN interfaces and their corresponding menus are presented in
sequence. Select the interface and menus appropriate to your unit.
Table 3-1. Main menu and second-level bridging commands
Main menu Second-level menus/description
adsl abort - abort ADSL line
bitdn - ADSL downstream bit loading value
bitup - ADSL upstream bit loading value
coding - <0>|<1>|<2>|<3>|<4>|<5>|<6>|<Auto> dB -
coding gain
counts - display ADSL counters
default - reset to default ADSL setting
ec_fdm - <Ec>|<Fdm> - set EC or FDM mode
rx_bin - <start_bin> <end_bin>
show - display ADSL parameter configuration
startup - restart ADSL line
status - display ADSL line status
stnl - <T1.413>|<g.Lite>|<g.Dmt>|<Multi Mode>
trellis - <Enable>|<Disable> - Trellis encoding
tx_pwr - <0> .. <12> dB - Tx power attenuation
tx_bin - <start_bin> <end_bin>