Lucent Technologies CELLPIPE 7820-0766-004 - Manual (Page 23)

Command-Line Interface
Routing commands
CellPipe™ 20 Series User’s Guide 3-7
The following main menu commands are displayed for routing mode:
xdsl* - entry to xdsl menu
default - set all configuration to factory setting
dnsrelay - entry to DNS Relay menu
ipoa - entry to IPoA menu
lan - entry to Ethernet
list - list status for enabled PVC
manage - entry to management menu
mode - exit this menu and change modem mode
pat - entry to PAT menu
ping - ping IP for testing purpose
pppoa - entry to PPPoA menu
quick - quick setup
r1483 - entry to RFC 1483 menu
restart - reboot modem
rtable - entry to Routing Table menu
save - save and restart modem
show - display configuration of PVC and Ethernet
ver - display software version
Note: *The WAN interface displayed in the menu is dependent on the interface
supported by your unit. This generic form of presentation has been arrived at to
eliminate the need of representing every interface.
Most of the routing commands are similar to those under bridging mode. Table 3-2
lists only the additional routing commands and their corresponding second-level
menus that appear when routing is selected.
Table 3-2. Additional main-menu and second-level routing commands
Main menu Second-level menus/description
dnsrelay setdnsip - set DNS server IP
show - show DNS Relay configuration