Lucent Technologies CELLPIPE 7820-0766-004 - Manual (Page 41)

Configuring a 20 Series CellPipe
Configuring the pat command
CellPipe™ 20 Series User’s Guide 4-15
Confirm Password again: ******
Pass has been changed
Select the deluser command to delete a user of a pppoa connection.
>pppoa> deluser
Select the echo command to input the echo time interval and enable LCP echo
cancellation.
>pppoa> echo <interval time>
Select the setllc command to enable or disable logic link control (LLC).
>pppoa> setllc <e>nable|<d>isable
Select the setqos command to set the class for quality of service.
>pppoa> setqos [<vpi>/]<vci> <ubr|cbr>
Select the setrip command to set up for RIP.
>pppoa> setrip <1|2|1&2|0>
Select the show command to display the PPPoA routing setting.
>pppoa> show
PPPoA dial out setting:
Function VPI/VCI Class PCR (Kbits) UserID/Auth
PPPoA 2/32 ubr 640 Lucent/CHAP
LLC = Disable Echo interval time: 60 s
Configuring the pat command
The following is a list of the menus available under the pat command:
addpatin - add incoming PAT table
delpatin - delete incoming PAT table
setpat - enable or disable PAT function
show - show PAT configuration