Lucent Technologies CELLPIPE 7820-0766-004 - Manual (Page 31)

Configuring a 20 Series CellPipe
Configuring WAN interface
CellPipe™ 20 Series User’s Guide 4-5
coding - <0>|<1>|<2>|<3>|<4>|<5>|<6>|<Auto> dB - coding gain
counts - display ADSL counters
default - reset to default ADSL setting
ec_fdm - <Ec>|<Fdm> - set EC or FDM mode
rx_bin - <start_bin> <end_bin>
show - display ADSL parameter configuration
startup - restart ADSL line
status - display ADSL line status
stnl - <T1.413>|<g.Lite>|<g.Dmt>|<Multi Mode>
trellis - <Enable>|<Disable> - Trellis encoding
tx_pwr - <0> .. <12> dB - Tx power attenuation
tx_bin - <start_bin> <end_bin>
Select the abort command to abort the ADSL connection.
>adsl> abort
Abort ADSL connection
Select the bitdn command to obtain the downstream bit loading value.
>adsl> bitdn
Select the bitup command to obtain the upstream bit loading value.
>adsl> bitup
Select the coding command to set the ADSL coding gain:
>adsl> coding - <0>|<1>|<2>|<3>|<4>|<5>|<6>|<Auto> dB - coding
gain
Select the default command to set the ADSL configuration back to factory setting.
>adsl> default
Set ADSL configuration back to factory setting
Select the ec_fdm command to configure the ADSL link for echo cancellation or
frequency division multiplexing (FDM).
>adsl> ec_fdm <Ec>|<Fdm>