Lucent Technologies CELLPIPE 7820-0766-004 - Manual (Page 21)

Command-Line Interface
Bridging commands
CellPipe™ 20 Series User’s Guide 3-5
sdsl auto - <Enable>|<Fast>|<Scan>|<Disable>
cell - <Enable>|<Disable> idle-cell header
dbit - configure the SDSL data bit as normal or reverse
polarity
default - set SDSL configuration back to factory setting
enable - activate the last updated SDSL parameters
maxrate - configure the SDSL autobuad max rate
rate - manually configure the SDSL line rate
scramble - <Enable>|<Disable> payload scrambling
smbit - configure sign/magnitude bit sequence
status - display the configuration and status of current
SDSL setting
terminal - configure modem to COE or CPE mode
default set all configuration to factory setting
lan fullduplex - fullduplex <Disable>|<Enable>
setip - setup the IP address, and subnet mask for Ethernet
connection
show - show LAN configuration
list list status for enabled PVC
manage setpass - change password
mode please select bridge or router:(b/r,b)
ping ping IP
quick (for adsl) R1483(r)/ IPoA(i)/ PPPoA(p)
quick (for sdsl) configure VPI/VCI
Table 3-1. Main menu and second-level bridging commands (continued)
Main menu Second-level menus/description