Lucent Technologies CELLPIPE 7820-0766-004 - Manual (Page 28)

Configuring a 20 Series CellPipe
Configuring WAN interface
4-2 CellPipe™ 20 Series User’s Guide
When you power up the unit, it is set to default (factory settings) and the console will
display the following message:
Starting to download from remote server...
This means TURN-UP is enabled and is downloading the latest configuration
information.
To disable the feature, interrupt the download and manually configure the system.
To re-enable the feature, you need to select the default command and reinstall the
factory default configuration.
Configuring WAN interface
Currently the 20 Series units support SDSL and ADSL WAN interfaces.
SDSL commands and configurations
The following is a list of the menus available under the sdsl command:
auto - <Enable>|<Fast>|<Scan>|<Disable> autobaud rate function
cell - <Enable>|<Disable> idle-cell header
dbit - configure the SDSL data bit as normal or reverse polarity
default - set SDSL configuration back to factory setting
enable - activate the last updated SDSL parameters
maxrate - configure the SDSL autobuad max rate
rate - manually configure the SDSL line rate
scramble - <Enable>|<Disable> payload scrambling
smbit - configure sign/magnitude bit sequence
status - display the configuration and status of current SDSL
setting
terminal - configure modem to COE or CPE mode
Select the auto command to set values for autobaud rate function.
>sdsl> auto <Enable>|<Fast>|<Scan>|<Disable>
(Scan Rate: 2320, 1744, 1536, 1152, 768, 384, 192)