Lucent Technologies CELLPIPE 7820-0766-004 - Manual (Page 42)

Configuring a 20 Series CellPipe
Configuring the pat command
4-16 CellPipe™ 20 Series User’s Guide
Select the addpatin command to enable a local server’s IP address to be used as a
WAN access port.
>pat> addpatin <pppoa|wanip> <port>/<udp|tcp> <serverip>
Note: Prior to setting the local server as a WAN access port, you have to enable the
PAT function. See the setpat command below.
Select the delpatin command to disable the local server as a WAN access port.
>pat> delpatin <all>|<number>
Select the setpat command to enable or disable a specific PAT interface.
>pat> setpat <pppoa|wanip> <e>nable|<d>isable
Select the show command to display the Pat configuration.
>pat> show
PAT enabled interface:
Interface IP address
IPoA 210.62.2.195
PPPoA?.?.?.?
PAT incoming table
No. i/f name|WAN IP Port/Protocol Server IP
1 pppoa 434/udp 192.62.2.134
2 210.62.2.195 232/tcp 192.62.2.166