Lucent Technologies CELLPIPE 7820-0766-004 - Manual (Page 35)

Configuring a 20 Series CellPipe
Configuring the manage command
CellPipe™ 20 Series User’s Guide 4-9
Select the dhcpserver command to configure the range of IP addresses that are
associated with the subnet mask used for the DHCP server.
>lan> dhcpserver <range1 startIP> <range1 endIP> [<range2
startIP> <range2 endIP>] [<max-lease-time>]
- dhcpserver dns <dns ip1> [<dns ip2>]
Select the setdhcp command to set the DHCP mode of the unit.
>lan> setdhcp <server|client|disable>
Select the setip command to set the the IP address and subnet mask for the link.
>lan> setip <etherip[/<masknum>] [subnet mask]>|<dhcp>
Select the show command to display the LAN configuration. For example:
>lan> show
Ethernet ip: 149.198.65.46
Subnet mask: 255.255.255.0
FullDuplex:Enable
DHCP current setting : disable.
DHCP ineffective setting : disable.
Configuring the manage command
The manage command allows you to set the user password. When user enables a
password, the unit will time out after 10 minutes if there is no activity. The password
has to be re-entered to resume activity.
>manage> setpass
Password disabled
New Password:<password>
Configuring the mode command
The mode command allows you to select for either the bridging or the routing mode
of operation.