Lyngdorf Audio RoomPerfect RP-1 - Manual (Page 13)

1 3
3. If your integrated amplifi er or preamp has a ‘tape 2’ loop (sometimes called recording loop) or ‘Pre
in/out’:
Connect the output of the ‘tape 2’ loop / ‘Pre out’ to the input of the RP-1. •
• Then connect the output of the RP-1 to the input of the ‘tape 2’ loop / ‘Pre in’.
Using this confi guration enables you to use multiple audio sources without switching source and/or
cables, since the ‘tape 2’ loop ‘Pre in/out’ is always active and not depending on other used inputs
and outputs.
Source(s)
DPA-1 Digital Pre-Amplifier
RP-1
Integrated amp / Preamp-poweramp
When using Option 2 or a ‘tape 2’ loop as described in Option 3, be aware that your
amplifi ers volume control is set at an appropriate level when making the RoomPer-
fect calibration.
Please refer to the chapter “Setting the Measurement Volume Level” for further
information.