Adding more room measurements – Lyngdorf Audio RoomPerfect RP-1 User Manual

Page 21

Advertising
background image

2 1

For an optimal room correction it is very important that the measurements are:

1. performed more than 1 meter (approx. 3 feet) away from the loudspeakers,

2. not performed behind the loudspeaker, and

3. that there is at least 50 cm/1.5 ft between each measurement.

50

cm

3.

Not behind

loudspeaker

1.

2.

1m

When a random measuring position and microphone orientation has been chosen press Enter. The measur-

ing process will start and the display will show ‘Measuring room position 1’.

The measurement will stop prematurely if an error occurs during the measuring process. In this case, the

error message ‘Retry room measurement – press Enter’ is displayed. Press Enter to continue.

If it is an error that needs correcting, then correct the error (see RoomPerfect™ trouble-shooting) and pro-

ceed with the room position measurement by pressing Enter. The measurement has ended successfully

when the last measuring signal stops and the display shows ‘RoomKnowledge XX% - Measurement ok’.

This process is repeated at least three times and until the RoomKnowledge reaches 90%.

Adding more Room Measurements

If you have performed successful measurements and RoomKnowledge has reached 90%, the message

‘Add more room meas.? Yes/No’ is displayed.

At this point, or any time later, you can decide whether the acquired room measurements are suffi cient or

you wish to add further room measurements to learn more about the room’s acoustical information. Adding

more room measurements results in a higher RoomKnowledge, this in turn improves the room correction

fi lters.

Choose Yes to add more room measurements. The room measuring process is now continued as

described in the previous section.

Choose No when no additional measurements are required. The RP-1 will return to full scale output.

The message ‘Save guided measurement - Yes/No’ will be displayed when exiting a successfully completed

guided set-up.

Choose Yes to save the results of the guided set-up and calculate the focus and the global room

correction fi lters.

Choose No if you wish to exit the guided set-up without calculating any room correction fi lters, without

saving the performed measurement.

Advertising