Lyngdorf Audio RoomPerfect RP-1 - Manual (Page 14)

1 4
Setup options of Main and Line outputs
As described in “Routing” and “Crossover Frequency” there are many ways to utilize the Main and Line out-
puts. Here we have described the three most common set-up´s. Please note the products, outputs and cross-
over frequencies are chosen randomly in these descriptions. Combine them as you see fi t.
1. Single-amp set-up with full range main speakers (no subwoofer).
A poweramp is connected to Main Outputs Left and Right. No crossover is selected.
Speaker Poweramp Speaker
RP-1 Main Output Left
No filter
Main Output Right
No filter
2. Poweramplifi er and subwoofer set-up.
A poweramp is connected to the Main Outputs Left and Right and the highpass crossover is set at 80Hz.
The Subwoofer is connected to the Line Output and the lowpass crossover is set at 80Hz. Remember to
bypass or set the subwoofer cut-off frequency to maximum.
RP-1
Poweramp Active subwoofer Speakers
Main Output Left + Right
Highpass filter set at 80Hz
Line Output Right
Mono lowpass filter set at 80Hz
3. Lyngdorf 2+2 setup.
A poweramp is connected to Line Outputs Left and Right and the highpass crossover is set at 400Hz.
Lyngdorf boundary woofers are connected to Main Outputs Left and Right, through a poweramp, and
the lowpass crossover set at 400Hz.
RP-1
Poweramp Speakers Poweramp Boundary woofers
Line Output Left + Right
Highpass filter set at 400Hz
Main Output Left + Right
Lowpass filter set at 400Hz