Lyngdorf Audio RoomPerfect RP-1 - Manual (Page 4)

4
Operating Voltage
The RP-1 can be switched between 115V and 230V mains voltage.
In 115V mode the RP-1 requires a mains voltage of 100V-120V at 50-60Hz.
In 230V mode the RP-1 requires a mains voltage of 220V-240V at 50-60Hz.
The mains voltage setting for your RP-1 can be changed on the rear selector.
Make sure the rear selector is in the correct position and connect the power input
only to the appropiate AC source. The warranty will not cover any damage caused
by connecting to the wrong type of AC mains.
The RP-1 has three power modes:
OFF 1.
No circuitry is powered. Please note that some parts of the mains entry section still carry live mains.
STANDBY 2.
The microprocessor is active..
ON 3.
All circuits active.
Unpacking the RP-1
Carefully remove the unit and accessory kit from the carton, visually check for shipping damage.
Contact both the shipper and your Lyngdorf Audio representative immediately if the unit bears any sign
of damage from mishandeling. All Lyngdorf Audio equipment is carefully inspected before leaving our
factory.
Keep shipping carton and packing material for future use or in the unlikely event that
the unit needs servicing. If this unit is shipped without the original packaging, dam-
age could occur and void the warranty.
Serial Number Registration
Please record the serial number of your RP-1 here for future reference. The serial number is printed on
the label on the rear panel. You will need this serial number, should you ever require service for your
RP-1.
RP-1 serial number: _____________________