Lyngdorf Audio RoomPerfect RP-1 - Manual (Page 34)

3 4
Connectors
Mains Connector
Mains voltage to the RP-1 is applied via an IEC320 type connector. The supplied cable with safety ground
should be used to connect the RP-1 to a mains outlet.
Make sure the rear selector is in the correct setting and connect the power input
only to an appropiate AC source. The warranty will not cover any damage caused by
connecting to the wrong type of AC mains.
Always disconnect the RP-1 from the mains before changing any connections to its
inputs or outputs.
Balanced Inputs
The balanced XLR inputs are wired in accordance with IEC268:
Pin 1: Chassis and ground.
Pin 2: Hot (+).
Pin 3: Cold (-).
Shell: Chassis and ground.
Unbalanced Inputs
The unbalanced RCA inputs are wired in accordance with normal practice:
Shell: Chassis and ground.
Pin: Hot (+).
Cleaning and Maintenance
This unit does not require any regular maintenance except to keep its exterior clean. Simply wipe its exte-
rior with a clean soft cloth. A small amount of non-abrasive cleaner may be used on the cloth to remove
any excessive dirt or fi ngerprints. Do not use abrasive cleaners or cleaners containing liquid solvents.