Lyngdorf Audio RoomPerfect RP-1 - Manual (Page 26)

2 6
Input Sensitivity
Input Sensitivity
The Input Sensitivity setting enables you to match the line level output of your pre-amplifi er to the input
sensitivity of the Lyngdorf Audio RP-1. The normal settings are:
Select ‘High’ for input levels <= 2.2Vrms and the output/input levels of your pre- and power •
amplifi er will match.
•
Select ‘Low’ for input levels > 2.2V RMS.
• Select ‘High + Gain’ for input levels <=2.2Vrms and add an extra +6dB gain to increase the output
level of your pre-amplifi er to match your power amplifi er. This setting is only to be used in
special cases where the output level from your pre-amplifi er is too low to obtain full output
from your power amplifi er. In ‘High’ and ‘Low’ sensitivity the RP-1 has unity (0dB) gain.
Selecting the correct setting will prevent clipping/distortion and obtain full scale out-
put from your pre-amplifi er.
Advanced Setup
The sub menus accessible in the Advanced menu are:
Advanced setup
Routing
Line Out Level
Crossover freq
Delay
Firmware versions
Remote Control
Factory Reset
Filter Type
Communication
Communication
The sub menus accessible in the Communication menu are:
Communication
Comm Address Comm Speed
Comm Address
The Communication Address setting identifi es the RP-1 to the PC interface or other Lyngdorf products.
In master mode the Lyngdorf equipment is normally set for 1, and the addresses 2-99 can be used for
pre-amplifi ers etc., but nothing is restricted.
Comm Speed
The Communication Speed setting is the RS232 Link interface speed. The default setting is 57600 baud.
With different PC’s and different lengths of cables the settings can be changed to 9600 or 115200 baud.
If a multi-amplifi er set-up is installed with Master/Slave communication, a faster response can be ob-
served when using higher speeds.