Lyngdorf Audio RoomPerfect RP-1 - Manual (Page 35)

3 5
Technical Specifi cations
Audio
Parameter Value Note
Balanced input connectors 3 pin XLR, gold-plated. Case=Gnd, Pin1=Gnd,
Pin2=Hot(+), Pin3=Cold(-)
Balanced input impedance 10KOhm AC-coupled.
Unbalanced input connectors RCA (phono) jack, gold-plated. Case=Gnd, Tip=Hot(+)
Unbalanced input impedance 10KOhm AC-coupled
Input sensitivity 4.4V (2.2V with high sens.)
DAC Out impedance 50Ohm
Unbalanced output Unity 0dB according to input level
Balanced output Unity 0dB according to input level
Frequency Response 20 - 20KHz +/-0.1dB RoomPerfect Highpass Filter
-3dB at 18Hz
THD+N A-wgt
Analog to Analog
-103dB Neutral voicing - ref 4.4V
S/N Ratio
Analog to Analog
113dB Neutral voicing - ref 4.4V
Dynamic Range
Analog to Analog
113dB Neutral voicing - ref 4.4V
Channel Separation 114dB AC Sweep from 125 - 16KHz
All audio measurements, except frequency response, are measured with a 20KHz low-pass fi lter in ac-
cordance with AES-17.
Protection
Parameter Value Value
Grounding Mains earth, chassis and audio
ground are connected internally.
Over temperature Mains-transformer. Auto resetting thermal fuse in
mains transformer.
Mains
Parameter Value Note
Mains input connector IEC 320 cold type Mains lead supplied.
Mains voltage range 100-240V AC, 50–60Hz
Power consumption 4 W STANDBY mode. 230V AC.
Power consumption 23 W OPERATE mode. 230V AC.
Mechanical
Parameter Value Note
Width 450mm (17.72”)
Depth 355mm (13.98”)
Height 100mm (3.94”) Including feet.
Net weight 6.6 Kg (14.6 lb.)
Shipping weight 9.9 Kg (21.8 lb.) 2 shipping boxes