Panasonic KX-FP195 - Manual (Page 35)

1 2 3
4 5 6
7 8 9
0
35
Advanced
Operations
Transmitting documents to multistations
This feature is useful when frequently sending the same documents to selected parties whose phone numbers
are stored in direct call stations and speed dial stations. You must program these stations into the BROAD
CAST key (direct call station 1).
Important:
¡ Before programming, make sure that the desired phone numbers have been stored into the direct call
stations or speed dial stations.
¡ The BROAD CAST key can be used as direct call station 1 or as the broadcast key.
Programming the BROAD CAST key with phone numbers
1 Press (MENU) until the following is displayed.
Display:
2 Press (BROAD\CAST) .
3 Press or to select “PROG. MODE”.
4 Press (START/COPY/SET) .
5 Enter the phone numbers.
a: Using direct call stations:
For upper stations 2–9, press the preset
direct call station key.
For lower stations 10–18, press
(LOWER) ,
then press the preset direct call station key.
b: Using speed dial stations:
Press K and the preset 2-digit number
(00–99 for KX-FP200 and 00–59 for
KX-FP195).
¡ To enter other phone numbers, repeat this step
(up to 117 stations for KX-FP200, 77 stations for
KX-FP195).
6 Press (START/COPY/SET) after entering all of the
desired phone numbers.
7 Press (STOP) .
NO.= [001]
PROG. MODE [ Ÿÿ ]
DIAL MODE [ Ÿÿ ]
STORE TEL NO.
Note:
¡ If you make a mistake while programming, press (STOP) , then make the correction.
¡ Confirm that you have correctly stored the numbers by printing a telephone number list (see page 56).
(MENU)
(START/COPY/SET)
(STOP)
(LOWER)
Direct call stations
(BROAD\CAST)
Speed dial
stations