Phonetics Boat Remote - Manual (Page 20)

Boat Remote User’s Manual
20
To mount the switch, follow these steps:
1. Place the switch on a horizontal, flat surface in the bilge, at
the desired location.
2. Gently lift the float and mark the location of the front screw.
3. Move the switch away from the location mark and drive in one
of the screws provided approximately 1/2" from the flat
surface, so that the switch can easily slide under the head of
the screw.
4. Slide the float switch under the head of the screw and then
drive the second screw provided into the back screw hole,
being careful not to overly tighten the screw as this may
distort the switch and impair its operation.
Electrical:
Connect the wires from the float switch to the HIGH WATER termi-
nals on the Boat Remote. Additional wire is included in the Installa-
tion Kit, or use 2-conductor 16-22AWG, to extend the wire from the
float switch. Keep all wire connections above the highest water level.
Cutting the switch wires may void the warranty and/or cause
premature failure. All wire connections should be sealed with
elastomeric sealant to prevent wire corrosion.
Fig. 2.3 Connecting the High Water Float Switch