Phonetics Boat Remote - Manual (Page 84)

Boat Remote User’s Manual
84
allow local keypad programming of pertinent operational data
including, but not limited to:
1. High and Low Limits (temperature, battery voltage)
2. Maximum continuous run-time (Bilge pumps)
3. Maximum cycle rate (Bilge pumps)
4. Alarm recognition time
5. Operating mode: Active, Status-only, Off
6. Input Type (NO/NC)
7. Telephone call list
B. Output
The system shall have one built-in 12V output. The output may be
programmed to switch when any alarm occurs or only when a
security alarm occurs. The 12V power is derived from the boat
battery input and is fused at 3A.
III. Communications Features
A. Telephone Specifications
The system shall connect to a standard two-wire telephone line
using pulse or tone, with loop start only. The system shall recognize
ringer frequencies from 16 to 60Hz. No leased or dedicated lines
shall be required. The system shall also be capable of being used on
the same line as other answering devices. Call progress detection
shall ensure that the alarm dial out is not hindered by no answers or
busy signals.
B. Telephone Numbers
The system shall be capable of dialing up to 8 telephone numbers,
32 digits each. The system shall allow local keypad programming of
the following telephone dialing information.
1. Dialing method (pulse or tone)
2. Message repetitions (1-10)
3. Maximum number of calls (0-255)
4. Call delay time (0-999min 59sec)
5. Intercall Delay time (30sec-999min 59sec)
6. Telephone Answering Device Compatibility