Phonetics Boat Remote - Manual (Page 76)

Boat Remote User’s Manual
76
SOLUTION: Replace the temperature sensor with a 10K sensor
from Phonetics or an approved alternate source.
OTHER MONITORING
PROBLEM: The alarm status of the security or auxiliary input is
incorrect.
CAUSE: The input normality, open/closed, is incorrect.
SOLUTION: Reprogram the input normality for the appropriate input.
PROBLEM: False power failure alarms.
CAUSE: The programmed recognition time is too short.
SOLUTION: AC power is often subject to brief interruptions. To avoid
frequent, false alarms, increase the power recognition time.
PROBLEM: The Boat Remote does not recognize power failure.
CAUSE: The power input is not programmed for the active mode.
SOLUTION: Reprogram the power input to be ACTIVE.
CAUSE: The power has not been off long enough to meet the
recognition time.
SOLUTION: Reprogram the power recognition time.
CAUSE: The Boat Remote is not connected to the 12V boat battery.
SOLUTION: Connect the boat battery to the 12VDC input, refer to
Installation Chapter.
PROBLEM: The bilge pump input does not count on/off cycles.
CAUSE: The bilge pump input is in OFF mode.
SOLUTION: Reprogram the bilge pump input for ACTIVE mode.
CAUSE: The bilge pump is not wired properly to the Boat remote.
SOLUTION: Double check the wiring to the bilge pump or float
switch, refer to the wiring diagrams in the Installation Chapter.
PROBLEM: The Boat Remote does not turn on when you plug
in the power supply.
CAUSE: The ON/OFF switch below the access panel is turned OFF.
SOLUTION: Remove the bottom access panel and turn the switch
ON.
CAUSE: Blown fuse.