Phonetics Boat Remote - Manual (Page 68)

Boat Remote User’s Manual
68
“Indicate you have received warning message.”
6) The answering machine can’t enter the acknowledgment code, so
after 10 seconds Boat Remote will say:
“Error.”
7) The unit hangs up.
8) Boat Remote waits 2 minutes (programmed Intercall Delay time)
then dials the next number on the dialout selection list (phone #4,
your primary residence, 555-4444).
9) The call is answered.
10) Boat Remote recites the following message 3 times (pro-
grammed number of voice repetitions)
“Hello, this is (Boat Remote ID Message).
“Bilge Pump #1 cycle rate exceeded. 5 cycles in the last 24 hours.”
11) After the third repetition, the unit will request acknowledgment:
“Indicate you have received warning message.”
Acknowledgment
1) You enter the ‘555’ acknowledgment code. The unit then says:
“Alarm acknowledged”
2) The unit will then hang up. The alarm has been acknowledged
and the dialout sequence stopped.
NOTE: Boat Remote will not dial out again for a Bilge Pump #1
alarm unless the input returns to its normal state and then is tripped
again.
EXAMPLE 2 (Away Mode: voice dialout & acknowledgment)
Alarm Recognition
Your boat’s slow leak has suddenly become a serious leak and the
bilge pumps can’t keep up with the incoming flow of water. The
rising water trips a float switch wired to the High Water input of your
Boat Remote. The float switch remains closed for 1 minute (the
programmed alarm recognition time) and the High Water input is set
to “Active” so Boat Remote enters the Alarm Notification sequence.
Alarm Notification
1) Boat Remote waits 30 seconds (the programmed Call Delay