Panasonic CF-T1 - Manual (Page 42)

42
SD Memory Card/MultiMedia Card
[Setting for this computer]
[Use the SD card when starting the computer]:
●
Add the check mark if you want to use the SD memory card instead of a
password entry in order to start the computer.
●
Removing the check mark erases the information pertaining to all SD memory
cards currently registered on the computer. You will no longer be able to start
the computer with any previously registered SD memory card. Remove the
check mark if there is a possibility of unauthorized card use by another party
(e.g., if you lose an SD memory card).
<If you remove the check mark>
• Removing the check mark from [Use the SD card when starting the
computer] does not disable the Supervisor Password. (The password input
screen appears when the computer is started.)
• To prevent the password input screen from appearing, run the Setup Utility
and disable the Supervisor Password. (
Ÿ page 20
)
●
Note that once you remove the check mark, if you want to use the SD memory
card again, you will need to reenter [Use when starting the computer] under
[Setting for this SD card].
●
This setting can also be done on [Security] menu of the Setup Utility.
[Use the SD card when logging on to Windows]:
●
Add the check mark if you want to use the SD memory card instead of a
password entry in order to log on to Windows.
●
If you remove the check mark, you will not be able to log on to Windows by
inserting an SD memory card with a set password.
[Key setting methods]:
●
Perform step 5 under [Initialization (SD Card Setup)]. (
Ÿ page 38
)
●
Changing the setting for [Use the SD card when starting the computer] can also
be done on [Security] menu of the Setup Utility.
●
If you want to change the setting method between [Use the SD card when
starting the computer] and [Use the SD card when logging on to Windows],
select the setting method using this screen when you log on to Windows, then
select the setting method using [Security] menu in the Setup Utility during
computer startup. When the setting method is changed in this way, the settings
in the Setup Utility will also be changed.