Pioneer VSA-AX10 - Manual (Page 45)

SURROUND SETUP
45
En
Setting Up for Surround Sound
Check the Auto Settings
5
If you want to check what settings have been input for your surround sound parameters you can do it following
the steps below.
1 Switch on the amplifier and your TV.
Make sure your TV is set to this amplifier as you will use
the on-screen displays on your TV to follow these
instructions.
2 Press the SUB button on the remote
control's AMPLIFIER screen.
3 Press the SYSTEM SETUP button and
use the on-screen display (OSD) that
appears on your TV.
The SYSTEM SETUP menu appears on the OSD.
4 Use the
5∞ buttons to select
SURROUND SETUP and press ENTER.
5 CHECK should be selected, press
ENTER.
6 The first menu in which you can check
your settings will appear. This is the
speaker settings.
Navigate this menu with the
2 3 buttons.
7 When you want to check the next
settings select NEXT with the
5∞
buttons and press ENTER.
The order of the settings menus is: Speaker Systems;
Channel Delay; Channel Level; Acoustic Calibration EQ.
If you want to leave the settings check select RETURN
with the
5∞ buttons and press ENTER.
8 Continue to move through the menus
using the
5∞ buttons and pressing
ENTER until you are done checking the
settings.
9 To exit the this mode select RETURN
with the
5∞ buttons and press ENTER.
You will return to the SURROUND SETUP menu. Then
select EXIT and press ENTER to exit the setup process.
STATUS SPEAKER
A/B
LOUDNESS
INPUT
ATT.
Amplifier MAIN SUB
SIGNAL
SELECT
TAPE 2
MONITOR
SYSTEM
SETUP
DISPLAY
DIMMER
VIDEO
SELECT
EFFECT/
CH SEL.
BASS/
ATREBLE
TONE
AMP
DVD/LD
VCR1
/DVR
VCR2
VCR3
TV
REMOTE
SETUP
CD-R/
TAPE1
CD
TUNER
VIDEO
SAT
TV
CONTROL
1
2
3
2.Surround Setup
[ Check ]
[ 1.Speaker Systems ]
[ 2.Channel Delay ]
[ 3.Channel Level ]
[ 4.Acoustic Cal EQ ]
[Return]