Pioneer VSA-AX10 - Manual (Page 55)

Basic Operation
BASIC
55
En
Adjusting Bass and Treble (TONE CONTROL)
You can adjust the low (bass) and high (treble) frequencies. The TONE button can also be used to bypass the
tone circuitry.
memo
• The tone control can be adjusted in a range of ±6 dB.
• The tone control cannot be set on in HOME THX, MIDNIGHT or LOUDNESS modes.
• If the amplifier is in DIRECT mode and you press the TONE button, TONE: BYPASS appears in
the display. You will need to press TONE once more to switch the tone control on, canceling the
(MULTI CH IN or STEREO) DIRECT mode.
1 Press the TONE button on the
remote control's AMP SUB screen or
front panel to put the amplifier in
tone adjust mode.
There are two tone modes TONE: ON and TONE:
BYPASS. The first means the tone functions are active
and also lets you adjust these functions. The second
means the tone controls are being bypassed, and thus
have no effect on the sound.
If TONE: BYPASS appears, press the button again to
get TONE: ON, which is the tone adjust mode.
2 Press the BASS/TREBLE button
repeatedly to select BASS or
TREBLE.
3 Use the +/– buttons to adjust the low
or high frequency levels.
A few seconds after you finish adjusting the tone the
amplifier will revert to the sound mode it was in at the
beginning of the process.
3
1
SUB
3
STATUS SPEAKER
A/B
LOUDNESS
INPUT
ATT.
Amplifier MAIN SUB
SIGNAL
SELECT
TAPE 2
MONITOR
SYSTEM
SETUP
DISPLAY
DIMMER
VIDEO
SELECT
EFFECT/
CH SEL.
BASS/
TREBLE
TONE
2
3 1 2