NEC SIGMABLADE N8406-020 - Manual (Page 128)

- 128 -
Checking Current Zoning
1. Type "cfgshow" on the console screen.
„ Any commands used on the switch console should be specified with
lowercase letters.
2. The current zoning information appears.
Without zoning information, skip to "Creating zone alias name" and following.
With some zoning information, recheck setting change to take proper action.
<No existence of zoning information>
HW060000955:admin> cfgshow
Defined configuration:
Effective configuration:
Effective configuration:
no configuration in effect
HW060000955:admin>
<Existence of zoning information>
HW060000955:admin> cfgshow
Defined configuration:
cfg:
zone_cfg
zone1; zone2
zone: zone1 1,0; 1,1
zone: zone2 1,4; 1,5
Effective configuration:
cfg:
zone_cfg
zone: zone1 1,0
1,1
zone: zone2 1,4
1,5
„ If enabled zoning information appears, take note on change of zoning
information. Zoning information is actually changed when configuration is
enabled after the change. Some setting errors before and/or after zoning
change may cause a system fault to occur.