NEC SIGMABLADE N8406-020 - Manual (Page 131)

- 131 -
2) Creating zone
Use the "zonecreate" command to create a zone.
„ Format of "zonecreate" command
zonecreate "zonename" , "member;member;member"
(1) (2)
(1) zonename:
Specify a zone name with it enclosed by double quotation marks (").
(2) member:
Specify a domain ID and a port number (decimal) with them delimited by a comma (,).
„ Delimit the zone name and the first port with a comma (,).
„ Delimit adjacent port specifications with a semicolon (;).
„ A zone name can be up to 64 alphanumeric characters.
„ This command must be done by the number of zones to be created.
3. Use the "zonecreate" command on the console screen to create zones.
HW060000955:admin> zonecreate "zone1","1,0;1,1"
HW060000955:admin> zonecreate "zone2","1,2;1,3"
HW060000955:admin> zonecreate "zone3","1,4;1,5"
HW060000955:admin> zonecreate "zone4","1,6;1,7"
HW060000955:admin>
„ Any commands used on the switch console should be specified with
lowercase letters.
4. Type "zoneshow" on the console screen.
HW060000955:admin> zoneshow
Defined configuration:
zone: zone1 1,0;1,1
zone: zone2 1,2;1,3
zone: zone3 1,4;1,5
zone: zone4 1,6;1,7
Effective configuration:
no configuration in effect
HW060000955:admin>
„ Confirm that all created zones appear by using the "zonecreate" command.
„ After a zone name, ports contained in the zone appear. Confirm that the
specified ports appear normally.