Ratoc Systems CBFW3 - Manual (Page 11)

7
2. Setup for Windows
To use the CBFW3 on Windows, follow the steps.
1.Insert the CBFW3 into the PC Card slot. Refer to the Chapter 2-1.
2.Install the OHCI driver. Refer to the Chapter 2-2.
3.Connect an IEEE1394 device to the CBFW3.
If you connect a DVCAM, refer to the Chapter 2-3.
If you connect a CCD camera, refer to the Chapter 2-4.
If you connect a 1394 storage device, refer to the Chapter 2-5.
4.If you want to capture a video from a DVCAM, install RsDvCap. Refer to the Chapter 3.
2-1.Inserting the CBFW3
Insert the CBFW3 into the PC Card slot as shown below.
Refer to the manual that accompanied with your PC for the location of the PC Card slot.
NOTE
You may not be able to insert another PC Card with the CBFW3 simultaneously.
You may not be able to insert the CBFW3 in the upper PC card slot.