Ratoc Systems CBFW3 - Manual (Page 21)

17
2-3.DVCAM Installation
This section describes how to connect a DVCAM and install the DV driver.
Connect the CBFW3 and a DVCAM using the IEEE1394 cable as shown below.
And turn on the DVCAM power switch. You can connect the DVCAM without turning off the PC
or DVCAM.
4pin-6pin IEEE1394 cable which
comes with this package
When your Windows version is Windows 98 SE(Second Edition), go to the Chapter 2-3-1.
When your Windows version is Windows 2000, go to the Chapter 2-3-2.
When your Windows version is Windows Me(Millennium Edition), go to the Chapter 2-3-1.
NOTE
Refer to the manual that accompanied your DVCAM for the location of DV connector.
DV connector