Ratoc Systems CBFW3 - Manual (Page 51)

47
5-2.How to save a BMP file
(1)Save a BMP file from a DV tape
1.Set a DV tape in a DVCAM and confirm the DVCAM mode is set to video mode.
Video Mode means you can control a video of a DV tape. If the DVCAM is in camera mode,
change mode selection switch from camera mode to video mode slowly as mentioned 4-4.
Capturing a video from a DVCAM in camera mode.
2.Starting RsDvStill, your DV tape will be paused and the button is disabled.
Set DV Maker and decide Image Size.
3.Click the button. You will see the dialog box. Select a folder where you want to
save a BMP file and click OK. If you don’t select a folder, a BMP file will be saved in the
folder where this application is installed.
4. Find a favorite scene on the DV tape, using the camera control button.
(TIPS)
When the button is disabled, click the button and the button.
You can preview slowly. When the button is enabled, click the button.
After that,click the button and the button. You can preview slowly.
5.There are two ways to save a BMP file as follows.
5-1.Click the button. The BMP file will be saved in the folder under the name
of “Image+ (number) + .BMP” and the BMP file will be held at the top of the
thumbnail window. If you double click the thumbnail, you can view it with real BMP
file size. If you click the thumbnail with the right button, the pop-up menu will show up.
If you select “Rename”, the following window will show up. Type in a new file name and
click [OK] to change the file name. If you select “Delete Bitmap File”, the thumbnail will
be deleted.
5-2.Click the button. After capturing, the DV tape will be paused. Then move
the slider to a favorite scene and click the button. The BMP file will
be held as mentioned above. If you want to resume previewing, click the button.