Ratoc Systems CB31U - Manual (Page 64)

W
indows2000
6. How to install Windows 2000
62
6. Installing Windows 2000
This chapter explains how to install Windows 2000 from a SCSI CD-ROM connected to the CB31U.
If you upgrade Windows 98, Windows NT to Windows 2000 , refer to Chapter 6-1.
If you install a new copy of Windows 2000(Clean Install), refer to Chapter 6-2.
If you install Windows 2000, using a Windows 95/98 startup floppy disk, refer to Chapter 6-3.
6-1. Upgrade Windows 98, Windows NT to Windows 2000
Follow these steps through:
1.Connect your CD-ROM to the CB31U first. Then start Windows98/WindowsNT.
2.Copy [i386] directory in the Windows2000 CD-ROM to the internal HDD.
3.Remove the CB31U and start the [WINNT32.EXE] file in the [i386] directory copied from Windows2000
CD-ROM.
4.When setup starts, you can see two ways to install Windows2000 on the screen:
-[Upgrade to Windows2000(Recommended)]
-[Install a new copy of Windows2000(Clean Install)]
5.Select [Upgrade to Windows2000(Recommended)].
6.Install Windows 2000, following the instructions.
7.When you finish installing it,set up the CB31U if you need it.