Ratoc Systems CB31U - Manual (Page 70)

68
7. Linux
Linux
* Restriction
To execute ascconf
To execute ascconf, the driver modules of the CB31U need to be loaded. If the modules are not loaded
, error message shows up like below.
Not found host adapter
Sometimes, you might see following messages.
Driver module does not active.
You must connect some scsi devices, then reboot system.
At that time, connect a SCSI device and turn on the device power and reboot the system.
* Executing ascconf
[format]
ascconf <command=parameter>
[command, parameter]
-v
To show the status of current setting
-x
To show the value of EEPROM (Hex)
--disc_all=<on | off>
To set enable/disable of Disconnect for all SCSI ID
(for example)
--disc_all=on : enable Disconnect with SCSI-ID 0-7
--disc_all=off : disable Disconnect with SCSI-ID 0-7
--disc<n>=<on | off>
To set enable/disable of Disconnect for specific SCSI ID
(for example)