Roland XV-5080. - Manual (Page 105)

105
Chapter 2 Using the XV-5080 Effects
Chap.2
500Hz (500Hz Gain)
Specifies the gain (amount of boost or cut) at 500 Hz.
1000Hz (1000Hz Gain)
Specifies the gain (amount of boost or cut) at 1000 Hz.
1250 Hz (1250 Hz Gain)
Specifies the gain (amount of boost or cut) at 1250 Hz.
2000 Hz (2000 Hz Gain)
Specifies the gain (amount of boost or cut) at 2000 Hz.
3150 Hz (3150 Hz Gain)
Specifies the gain (amount of boost or cut) at 3150 Hz.
4000 Hz (4000 Hz Gain)
Specifies the gain (amount of boost or cut) at 4000 Hz.
8000 Hz (8000 Hz Gain)
Specifies the gain (amount of boost or cut) at 8000 Hz.
Band Width
Q
Specifies the range of all bands in which the level will be
modified.
Output
Level (Output Level) #
Adjusts the output level.
89: 3D AUTO SPIN
The 3D Auto Spin effect rotates the location of the sound.
fig.02-089m.e
Auto Spin
Azimuth
Sets the location at which the sound will stop when rotation
is stopped. A setting of “0” positions the sound in the center.
Speed #
Sets the speed of rotation.
Clockwise
Sets the direction of rotation. A setting of “-” produces
counterclockwise rotation, while at “+” it will be clockwise.
Turn #
Stops or starts the rotation. When this is turned On, the
sound will rotate. When turned Off, rotation will stop at the
location specified by Azimuth.
Output
Out (Output Mode)
Specifies the method that will be used to reproduce the
sound that is output to the OUTPUT jacks. The optimal 3D
effect will be achieved if you select
SPEAKER when using
speakers, or PHONES when using headphones.
Level (Output Level)
Adjusts the output level.
90: 3D MANUAL
This places the 3D effect at a desired location.
fig.02-090m.e
Auto Spin
Azimuth #
Specifies the location. A setting of “0” positions the sound in
the center.
Output
Out (Output Mode)
Specifies the method that will be used to reproduce the
sound that is output to the OUTPUT jacks. The optimal 3D
effect will be achieved if you select
SPEAKER when using
speakers, or PHONES when using headphones.
Level (Output Level)
Adjusts the output level.
L out
R out
L in
R in
3D Auto
L out
R out
L in
R in
3D Manual