Reverse delay 2(p. 83), Shuffle delay 2(p. 83), Reverse delay 2 – Roland XV-5080. User Manual
Page 83: Delay, Feedback, Hf damp, Level, Threshold, Eq gain, Balance
83
Chapter 2 Using the XV-5080 Effects
Chap.2
68: REVERSE DELAY 2
This allows you to set even longer delay times (max. 1500
ms) for the Multi-Tap Delay function.
fig.02-068m.e
Delay
1–4 (Delay Time 1–4)
Adjusts the delay time from the direct sound until the delay
1 – 4 sound is heard.
Feedback
1, 4 (Feedback 1, 4) #
Adjusts the proportion (%) of the delay 1 sound that is fed
back into the effect. Positive (+) settings will return the signal
to the input with the original phase, while negative (-)
settings produce an inverted phase.
HF Damp
1, 4 (HF Damp 1, 4)
Adjusts the frequency above which delayed sound (delay 1,
4) fed back to the delay input will be cut.
If you do not want to damp the high frequencies, set this
parameter to BYPASS.
Level
1–3 (Delay Level 1–3)
Sets the volume level of the delay sound (Delay 1 – 3).
Pan
1–3 (Output Pan 1–3)
Sets the stereo position of the delay sound (Delay 1). L64 is
far left, 0 is center, and 63R is far right.
Threshold
Value
Specifies the volume level at which the reverse delay will
begin to apply.
EQ Gain
Low (Low Gain)
Adjusts the gain of the low frequency range.
Positive (+) settings will emphasize (boost) the low-
frequency range.
High (High Gain)
Adjusts the gain of the high frequency range.
Positive (+) settings will emphasize (boost) the high-
frequency range.
Balance
Balance (Effect Balance) #
Sets the volume balance between the direct sound and the
effect sound.
With a setting of D100:0W only the direct sound will be output,
and with a setting of D0:100W the effect sound will be output.
Output
Level (Output Level)
Adjusts the output level.
69: SHUFFLE DELAY 2
This allows you to set even longer delay times (max. 3000
ms) for the Shuffle Delay function.
fig.02-069m.e
Delay
Time (Delay Time) #
Adjusts the delay time from the direct sound until the delay
sound is heard.
Shuffle Rate #
Sets the ratio (as a percentage) of the time that elapses before
the sound plays in Delay B relative to the time that elapses
before the sound plays in Delay A. When set to 100%, the
delay times are the same.
Acceleration
Adjusts the time over which the Delay Time will change
from the current setting to a newly specified setting.
Feedback
L in
R in
Rev. Delay
L out
R out
2-Band
EQ
2-Band
EQ
1
2
D1
Delay
3
D3
D2
D4
Feedback
L in
R in
Delay
L out
R out
2-Band
EQ
2-Band
EQ
1
2
Delay 1
Delay 2