Roland XV-5080. - Manual (Page 65)

65
Chapter 2 Using the XV-5080 Effects
Chap.2
41:STEREO PHASER
This is a stereo phaser. With the Step effects, you can also
make stepped changes in the pitch of sounds to which the
Phaser effect is applied.
fig.2-51
Phaser
Type (Phaser Type)
Selects the type of Phaser.
Type 2 adds more of the Phaser effect to the high frequencies
than Type 1.
Mode
Selects the number of stages in the phaser (4/8-STAGE).
Polarity
Selects whether the left and right phase of the modulation
will be the same or the opposite.
INVERSE: The left and right phase will be opposite. When
using a mono source, this spreads the sound.
SYNCHRO: The left and right phase will be the same. Select
this when inputting a stereo source.
Manual #
Adjusts the center frequency to which the phase effect is
applied.
Rate (Phaser Rate) #
Adjust the frequency of modulation.
Depth (Phaser Depth)
Adjust the depth of modulation.
Resonance (Phaser Resonance)
Adjust the amount of feedback for the phaser. Higher
settings will give the sound a stronger character.
X-Feedback (Cross Feedback Level)
Adjust the proportion (%) of the phaser sound that is to be
returned to the input. Positive (+) settings will return the
signal to the input with the original phase, while negative (-)
settings produce an inverted phase.
Mix Level
Adjust the volume of the phase-shifted sound, relative to the
direct sound.
Step Rate
Switch
This setting determines whether the pitch is changed in a
stepped fashion (ON) or not (OFF).
Rate (Step Rate) #
Adjust the frequency of pitch change.
EQ Gain
Low (Low Gain)
Adjust the low frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the low
frequency range.
High (High Gain)
Adjust the high frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the high
frequency range.
Output
Level (Output Level)
Adjust the output level.
42:KEYSYNC FLANGER
Keysync FLanger controls the Flanger by resetting the effect
at the volume of the sound input to the effects device,
restarting from the same pitch each time the Flanger is reset.
This parameter lets your playing dynamics on the keyboard
control the flanger effect.
fig.2-52
Flanger
PrDly (Pre Delay Time)
Adjust the time delay from the original sound until the
flanger sound is heard.
Rate (LFO Rate) #
Adjust the modulation frequency of the flanger sound.
R in R out
L in L out Phaser
Mix
2-Band
EQ
Phaser 2-Band
EQ
Mix
R in R out
L in L out
Flanger
Feedback
Feedback
Flanger
2-Band
EQ
2-Band
EQ