Roland XV-5080. - Manual (Page 88)

88
Chapter 2 Using the XV-5080 Effects
EQ Gain
Low (EQ Low Gain)
Adjusts the low-range gain of the equalizer.
Mid (EQ Mid Gain)
Adjusts the gain of the area specified by the EQ M Fq
parameter and the EQ M Q parameter.
High (EQ High Gain)
Adjusts the high-range gain of the equalizer.
Mid (EQ Mid Frequency)
Sets the center frequency for the equalizer mid-range.
Mid Q (EQ Mid Q)
Adjusts the width of the area centered at the EQ M Fq setting
in which the gain will be affected. Higher values of Q will
result in a narrower area being affected.
Pitch Shifter
Mode (PS Shifter Mode)
Higher settings of this parameter will result in slower
response, but steadier pitch.
Coarse Tune (PS Coarse Pitch) # *1
Adjusts the pitch of the pitch-shifted sound in semitone steps
(-2– +1 octaves).
Fine Tune (PS Fine Pitch) # *1
Makes fine adjustments to the pitch of the pitch shifted
sound in 2-cent steps (-100– +100 cents).
Delay (PS PreDelay)
Adjusts the time delay from when the direct sound begins
until the pitch-shifted sound is heard.
Feedback (PS Feedback)
Adjusts the proportion (%) of the processed sound that is fed
back into the effect.
Balance (PS Balance)
Adjusts the volume balance between the direct sound and
the pitch shifted sound.
Phaser
Mode (Phaser Mode)
Selects the number of stages in the phaser.
Manual (Phaser Manual) #
Sets the center frequency at which the phaser sound will be
modulated.
Rate (Phaser Rate) #
Adjusts the frequency of modulation.
Depth (Phaser Depth)
Specifies the depth of modulation.
Resonance (Phaser Resonance)
Adjusts the emphasis for the region around the center
frequency specified by the PH Man parameter.
Mix Level(Phaser Mix)
Adjusts the proportion by which the phase-shifted sound is
combined with the direct sound.
Delay
Left Time (Delay Time Left)
Adjusts the delay time from the original sound until the left
delay sound is heard.
Right Time (Delay Time Right)
Adjusts the delay time from the direct sound until the right
delay sound is heard.
Feedback (Delay Feedback Level)
Adjusts the proportion (%) of the delay sound that is fed
back into the delay input.
HF Damp
Adjusts the frequency above which sound fed back to the
effect will be cut. If you do not want to damp the high
frequencies, set this parameter to BYPASS.
Balance (Delay Balance) #
Adjusts the volume balance between the direct sound and
the delay sound.
Output
Level (Output Level)
Adjusts the output level.
* 1 In Realtime Control, the selected pitch is controlled with
these parameters.