Roland XV-5080. User Manual
Page 112
112
Chapter 3 Selecting Output Jacks
Part Chorus Send Level
Range:
0–127
Sets how much of the Part is sent to the Chorus. Its final
output destination is determined by the Chorus output
setting.
Part Reverb Send Level
Range:
0–127
Sets how much of the Part is sent to the Reverb. Its final
output destination is determined by the Reverb output
setting.
MFX Dry Send Level
Range:
0–127
Determines the level of the signal that is to be sent to the
output jacks, after passing through the Multi-effects.
MFX Chorus Send Level
Range:
0–127
Determines the level of the signal that is to be sent to Chorus,
after passing through the Multi-effects. Its final output
destination is determined by the Chorus output setting.
MFX Reverb Send Level
Range:
0–127
Determines the level of the signal that is to be sent to Reverb,
after passing through the Multi-effects. Its final output
destination is determined by the Reverb output setting.
Chorus Output Select
Specifies how the signal routed through Chorus will be
output.
Available Settings:
MAIN:
The Chorus output is sent only to the OUTPUT jacks.
REV:
The Chorus output is sent only to the Reverb.
M+R:
The Chorus output is sent to the OUTPUT jacks and to
the Reverb.
Chorus Level
Range:
0–127
Determines the Chorus output level.
Reverb Level
Range:
0–127
Determines the Reverb output level.
MFX Output Assign
Range:
A–D
Selects the pair of OUTPUT jacks to which the Multi-effects
stereo output is routed.
* As the Multi-effects are in stereo, settings for the
INDIVIDUAL OUTPUT jacks are unavailable.
Chorus Output Assign
Range:
A–D
Selects the pair of OUTPUT jacks to which the Chorus unit’s
stereo output is routed when Chorus Output Select is set to
“MAIN” or “M+R.” The output destination setting for the
signal sent to Reverb is determined according to the Reverb
settings.
* As the internal effects processors are in stereo, settings for the
INDIVIDUAL OUTPUT jacks are unavailable.
Reverb Output Assign
Range:
A–D
Selects the OUTPUT jacks to which the Reverb unit’s stereo
output is routed.
* As the internal effects processors are in stereo, settings for the
INDIVIDUAL OUTPUT jacks are unavailable.
SYSTEM Output page ([SYSTEM] - [F2
(OutP&EQ)])
Output Mix/Parallel
Mode
Available Settings:
MIX:
All sounds—including those routed to OUTPUTs B/C
or INDIVIDUAL 3–8—are mixed together and routed to the
A (MIX) OUTPUT jacks. This setting allows you to quickly
route everything through headphones when you are creating
sounds, or to combine all of your sounds into two outputs
when sending the XV-5080’s signal to a mixer that has only
two channels.
When MIX is selected, sounds routed to the INDIVIDUAL
OUTPUT 3/5/7 jacks are sent to the left A (MIX) OUTPUT
jack, and sounds routed to the INDIVIDUAL OUTPUT 4/6/
8 jacks are sent to the right A (MIX) OUTPUT jack.
PARALLEL:
Sounds are routed to output jacks according to
their output settings.
The XV-5080’s Master Level and Mix/Parallel settings are
each established using a single global parameter.