Roland XV-5080. - Manual (Page 84)

84
Chapter 2 Using the XV-5080 Effects
Feedback #
Adjusts the proportion (%) of the delay sound that is fed
back into the delay input. Positive (+) settings will return the
signal to the input with the original phase, while negative (-)
settings produce an inverted phase.
HF Damp
Adjusts the frequency above which delayed sound fed back
to the delay input will be cut.
If you do not want to damp the high frequencies, set this
parameter to BYPASS.
Pan
A, B (Pan A, B)
Adjusts the pan of the delay A, B sound.
Balance
Balance (Level Balance)
Sets the balance for the levels of the delay A and the delay B.
EQ Gain
Low (Low Gain)
Adjusts the gain of the low frequency range.
Positive (+) settings will emphasize (boost) the low-
frequency range.
High (High Gain)
Adjusts the gain of the high frequency range.
Positive (+) settings will emphasize (boost) the high-
frequency range.
Balance
Balance (Effect Balance)
Sets the volume balance between the direct sound and the
effect sound.
With a setting of D100:0W only the direct sound will be
output, and with a setting of D0:100W only the effect sound
will be output.
Output
Level (Output Level)
Adjusts the output level.
70: 3D DELAY 2
This allows you to set even longer delay times (max. 3000
ms) for the 3D Delay function.
fig.02-070m.e
Delay
Center (Delay Time Center)
Adjusts the delay time from the direct sound until the center
delay sound is heard.
Left (Delay Time Left)
Adjust the delay time from the original sound until the left
delay sound is heard.
Right (Delay Time Right)
Adjust the delay time from the direct sound until the right
delay sound is heard.
HF Damp
Adjusts the frequency above which delayed sound fed back
to the delay input will be cut.
If you do not want to damp the high frequencies, set this
parameter to BYPASS.
Feedback #
Adjusts the proportion (%) of the delay sound that is fed
back into the delay input. Positive (+) settings will return the
signal to the input with the original phase, while negative (-)
settings produce an inverted phase.
Delay Level
Center (Delay Level Center)
Adjusts the volume of the center delay sound.
Left (Delay Level Left)
Adjusts the volume of the left delay sound.
Right (Delay Level Right)
Adjusts the volume of the right delay sound.
EQ Gain
Low (Low Gain)
Adjusts the gain of the low frequency range.
Positive (+) settings will emphasize (boost) the low-
frequency range.
L
R
L out
R out
3D Delay L
3D Delay R
3D Delay C
Level
2-Band
EQ
2-Band
EQ