Roland XV-5080. - Manual (Page 151)

151
Chapter 4 Creating Patches
Chap.4
PATCH WG SMT#2 page ([PATCH] - [F2
(WG)] - [F2 (SMT)])
fig.04-063.e_70
SMT Velocity Control (SMT Velocity
Control Switch)
Range: OFF/ON
Determines whether Velocity messages from a MIDI
keyboard or sequencer will be recognized (ON), or ignored
(OFF).
L.F (SMT Velocity Fade Width Lower)
Range: 0–125
Determines the extent over which the sound level is faded
after SMT Velocity Range Upper.
V.L (SMT Velocity Range Lower)
Range: 1–126
Specifies the highest limit of playing dynamics (key velocity)
which will sound the Tone. Make these settings when you
want different Tones to sound in response to notes played at
different strengths.
V.U (SMT Velocity Range Upper)
Range: 2–127
Specifies the highest limit of playing dynamics (key velocity)
which will sound the Tone. Make these settings when you
want different Tones to sound in response to notes played at
different strengths.
* It is not possible to set the Lower value higher than the Upper
value, or the Upper value below the Lower value. If you
attempt to do so, the two values will change simultaneously.
U.F (SMT Velocity Fade Width Upper)
Range: 0–125
Determines the extent over which the sound level is faded
after SMT Velocity Range Upper.
PATCH WG Sample page ([PATCH] -
[F2 (WG)] - [F3 (Sample)])
fig.04-065.e_70
Sample
Sample
Select the sample to be edited.
Sampling Freq. (Sampling Frequency)
Displays the original sampling frequency of the loaded
Sample.
Original Key
Displays the original key of the loaded Sample.
Loop
Mode (Loop Mode)
Displays the loop mode of the loaded Sample.
Available Settings:
FORWARD:
After the Sample played back from the Start point to the
Loop End point, it will then be repeatedly played back in the
forward direction, from the Loop Start point to the Loop End
point.
Start
Loop
Start P. Loop
End P.