Raymarine C140w - Manual (Page 137)

10.4 Enabling or disabling AIS
1. To enable AIS in the chart application:
i. Press the PRESENTATION softkey.
ii. Press the CHART LAYERS softkey.
iii. Press the CHART LAYERS softkey.
iv. Press the AIS OBJECTS softkey repeatedly until the ON
option is selected.
v. Press the OK button.
2. To enable AIS in the radar application:
i. Press the PRESENTATION softkey.
ii. Press the AIS LAYER softkey repeatedly until the ON option
is selected.
iii. Press the OK button.
10.5 Displaying AIS vectors
You must have the correct data available before AIS vectors can
be displayed.
A target is defined as active when it has the following data displayed
graphically:
• A COG/SOG vector indicating the predicted distance that a target
will travel within a given period of time.
• A heading and direction of turn indicator.
Enabling and disabling AIS vectors
In the chart or radar application:
1. Move the cursor over the relevant AIS target.
2. Press the AIS VECTOR softkey until the ON or OFF option is
selected, as appropriate.
3. Press the OK button.
Note: The same target vector and safe zone settings apply to
both radar MARPA and AIS targets.
Using AIS 137