Raymarine C140w - Manual (Page 154)

Selecting a fishfinder preset
From the fishfinder main screen:
1. Press the appropriate softkey to select from:
• PRESET 1 SINGLE,
• PRESET 2 DUAL,
• PRESET 3 SHALLOW or
• PRESET 4 DEEP
After a few moments, the fishfinder display will change to the new
mode. This is indicated in the top left-hand corner of the status bar.
12.4 Fishfinder display modes
Selecting a fishfinder display mode
When a fishfinder preset is selected, its softkey label changes to
ADJUST. Pressing this softkey allows you to configure the display
mode settings to suit your requirements. (Changes to the display
mode are saved with the preset at power-off.)
From the fishfinder main screen:
1. Press the appropriate ADJUST... softkey.
2. With dual frequency screens select FREQ1 or FREQ2 to select
which frequency display you wish to change.
3. Press the SELECT VIEW softkey.
4. Use the trackpad up/down to select the required display mode:
• None,
• Zoom,
• Bottom Lock or
• A-Scope
5. Press OK when complete.
Fishfinder zoom mode
The zoom display mode magnifies a region of the fishfinder screen
to display more detail.
This zoom option enables you to:
• Replace the standard fishfinder image with the zoomed image,
or display the zoomed image alongside the standard fishfinder
image.
• Set the zoom factor to a predefined level, or adjust it manually.
154 C-Series Widescreen user reference