RCA Pro867 - Manual (Page 71)

62
Playback on a TV without AUDIO/VIDEO IN Jacks
To connect your camcorder to a TV without AUDIO/VIDEO IN jacks, you will need the
RF output adapter and coaxial RF cable that came packed with your camcorder. If your
TV has AUDIO and VIDEO IN jacks (or is connected to a VCR), refer to pages 60-61.
Installation
1 Disconnect the VHF antenna from
your TV. Connect the antenna to the
IN FROM ANT jack on the RF output
adapter if you are going to leave the
adapter connected to the TV.
Note: If your VHF antenna is the flat
twin-lead type attached by two screws,
you will also need an optional 300/75 ohm
transformer, such as 193983 shown on
page 3.
2 Attach one end of the coaxial RF cable
to the OUT TO TV jack on the adapter,
OR 1
OR
OR
2
3
2
VHF
VHF
Back of TV
VHF Antenna
Coaxial
RF Cable
(supplied)
CH3/CH4 Switch
RF Output Adapter
(supplied)
Optional 300/75 ohm
Transformer
(such as 193983)
AV (Audio/Video) IN/OUT Connector
(Located behind small cover)
Optional 75/300 ohm
Transformer
(such as AH011)
VHF Antenna IN FROM TV
OUT TO TV
CH3 CH4
and attach the other end to the VHF
input on your TV as shown.
Note: If your TV has 300 ohm VHF screw
terminals, you will need an optional 75/300
ohm transformer, such as AH011 shown on
page 3.
3 Attach the RF output adapter’s plug to
the AV IN/OUT connector of the
camcorder. Match the tabs on the plug
with the notches on the camcorder
connector. Do not force the plug.