Renesas Emulation Pod M306N4T3-RPD-E - Manual (Page 28)

( 28 / 76 )
Chapter 3. Setting Up
To use this emulation pod with your target system, it is necessary to set as follows. Set the following
after removing the upper cover.
• Oscillation frequency
• Switches
• Pullup resistors
• A-D conversion bypass capacitor
3.1 Removing and Closing the Upper Cover
(1) To open the upper cover, remove the four screws of both sides of this product and lift off the upper
cover (see Figure 3.1).
(2) To close the upper cover, attach the upper cover and secure the four screws of both sides of this
product.
Figure 3.1 Removing the upper cover
CAUTION
When Removing and Closing the Upper Cover:
• Always shut OFF power before opening the upper cover to change the switch
settings.
• Do not touch the connector pins of the PC4701 and the target MCU connector pins.
Static electricity may damage the internal circuits.