Renesas Emulation Pod M306N4T3-RPD-E - Manual (Page 36)

( 36 / 76 )
(2) Jumper Switches JP1 and JP2 on the M30620T3-PRT Board (MCU-dependent 1)
Table 3.4 Switch settings of the M306N4T3-RPD-E (3/4)
A18_SEL JP1
VDDIO
Signal Switch Setting Description
JP2
A18_SEL
4M
1M
(Factory-setting)
Use this setting.
Do not use this setting.
A18_SEL
4M
1M
Use this setting.
VCC1 > VCC2
JP2 Vcc1
||
VCC2
(Factory-setting)
VDDIO
VCC1 > VCC2
JP2 Vcc1
||
VCC2
VDDIO
Do not use this setting.
CAUTION
Note on Switch Settings:
• Always shut OFF power before changing switch settings.