Renesas Emulation Pod M306N4T3-RPD-E - Manual (Page 68)

( 68 / 76 )
(2) Program Window is Not Displayed at Debugger Startup (Target Connected)
Table 6.2 Checkpoints of errors when starting up the emulator debugger (target connected)
Error Checkpoint
(1) Check the connection between the PC4701 and host
machine.
See the PC4701 User's Manual.
(2) Check that the PC4701 is powered on.
See the PC4701 User's Manual.
(3) Check that all emulator debugger settings, interface
cable connection and switches on the rear of the
PC4701 match.
See the PC4701 User's Manual and the emulator
debugger online manual.
(1) Download the proper firmware.
See "4.2 Downloading Firmware" (page 50).
(2) Choose the proper MCU file in the Init dialog box.
See the emulator debugger online manual.
(3) Check that the descriptions in the MCU file are
correct.
See "2.4 (1) Making the MCU File" (page 25).
(1) Check the connection between the PC4701 and this
product.
See "3.7 Connecting the PC4701" (page 39).
(2) Check the reset pin of the target system is held high.
See the MCU specifications.
(3) If the CNVss is held high at startup, check that pins
HOLD* and RDY* are held high, too.
See the MCU specifications.
(4) Check that the oscillation circuit of the emulation pod
is oscillating properly.
See "3.3 Selecting Clock Supply and Replacing
Oscillator Circuit Boards" (page 30).
(1) Check that the oscillation circuit of the target system
is oscillating properly.
See "3.3 Selecting Clock Supply and Replacing
Oscillator Circuit Boards" (page 30).
(2) Check that the PC4701 LEDs at startup show normal
operation.
See "4.1 (3) LED Display When the PC4701 Starts
Up Normally" (page 49).
Check that the emulator debugger has not been started
up without shutting down the PC4701.
See "IMPORTANT: Note on Quitting the Emulator
Debugger" (page 12).
ERROR 16005:
Can't connect with the target.
ERROR 16211:
The version of PD30 and the firmware on
the target are not same.
ERROR 16215:
Cannot communicate with the debugging
monitor.
ERROR 16014:
Communication ERROR.
Can't accept data.
ERROR 16231:
There was sent undefined data from
PC4700.