Renesas Emulation Pod M306N4T3-RPD-E - Manual (Page 35)

( 35 / 76 )
Table 3.3 Switch settings of the M306N4T3-RPD-E (2/4)
Xout SW3
SW4 P86/Xcout
Signal Switch Setting Description
Does not connect pin Xout of the MCU to the target
system.
OP Xout
(Factory-setting)
SW3
Connects pin Xout of the MCU to the target system.
SW3
OP Xout
Xout
Xout
Connects pin P86/Xcout of the MCU to the target
system to use it as port P86 or Xcout.
P86/XC OP
(Factory-setting)
SW4
Does not connect pin P86/Xcout of the MCU to the
target system.
P86/Xcout
P86/XC OP
SW4
P87/Xcin SW5
CAUTION
Note on Switch Settings:
• Always shut OFF power before changing switch settings.
Uses pin P87/Xcin of the MCU as port P87.
Uses pin P87/Xcin of the MCU as Xcin.
P87 Xcin
P87 Xcin
(Factory-setting)
SW5
SW5
P87/Xcin
P86/Xcout
P87/Xcin
IMPORTANT
Note on BYTE and CNVss Switch Settings:
• Switch settings of the BYTE and CNVss are for debugging without the target system
connected.