Renesas Emulation Pod M306N4T3-RPD-E - Manual (Page 7)

( 7 / 76 )
Terminology
Some specific words used in this user's manual are defined as follows:
Emulator system
This means an emulator system built around the PC4701 emulator. The PC4701 emulator system is
configured with an emulator main unit, emulation pod, host machine and emulator debugger.
Emulator main unit (Hereafter PC4701)
This means a generic name for emulators for M16C, 7700, 740 Families. Take note of the fact that
the M306N4T3-RPD-E (this product) does not support the PC4701L and PC4700L emulators. For
details on specific models of PC4701, visit the Renesas Tool Homepage at http://www.renesas.com/
en/tools
Emulation pod
This means M306N4T3-RPD-E (this product). This emulation pod is for the M16C/6N Group M16C/
6N4, 6N5 MCUs. It is used with the emulator main unit PC4701.
Emulator debugger
This means a software tool M3T-PD30 for the M16C/60, M16C/30, M16C/20 and M16C/10 Series
MCUs. The M3T-PD30 controls the emulator from the host machine through various interfaces.
Host machine
This means a personal computer used to control the emulator and emulation pod.
Firmware
Program that analyzes contents of communication with the emulator debugger and controls the
emulator hardware. This program is installed in the EEPROM. This program is downloadable from
the emulator debugger to upgrade the firmware or to support other MCUs.
Target MCU
This means the microcomputer you are going to debug.
Target system
This means a user's application system using the microcomputer to be debugged.
User program
This means an application program to be debugged.
Evaluation MCU
This means the microcomputer mounted on the emulation pod which is operated in the specific mode
for tools.
*
In this user's manual, this symbol is used to show active LOW (e.g. RESET*: Reset signal).